Hybrid System Indicator Malfunction [08/2015 - ]: Procedure

1. Check for DTCs. Refer to DIAGNOSIS SYSTEM [08/2015 - ] .

   Result

   Result	Proceed to
   CAN communication DTCs are not output.	A
   CAN communication DTCs are output.	B

B → Refer to   8 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. Perform the Active Test according to the display on the Techstream.
   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   HV System Indicator	Hybrid System Indicator	MIN, -50, 0, 100, 200, 300, 400, MAX	-

   OK

   Hybrid system indicator indication is normal.

   RESULT
   
   

   Result	Proceed to
   OK	A
   NG (w/o Multi-information display)	B
   NG (w/ Multi-information display)	C

B → Refer to   6 

C → Refer to   10 

A: Go to next step 

1. Connect Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Data Test.
5. Read the Data List according to the display on the Techstream.
   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Hybrid System Indicator	Hybrid system indicator value/ Min.: -512, Max.: 511 (%)	-512 to 511 (%)	-

   OK

   Hybrid system indicator value displayed on the Techstream is almost the same as hybrid system indicator indication.

   RESULT
   
   

   Result	Proceed to
   OK (w/o Multi-information display)	A
   OK (w/ Multi-information display)	B
   NG	C

B → Refer to   5 

C → Refer to   7 

A: Go to next step 

1. Replace the meter circuit plate with a new or a known good one. Refer to DISASSEMBLY [08/2015 - ] .

   OK

   The operation of the hybrid system indicator returns to normal.

NG → Refer to   9 

OK → END 

1. Replace the combination meter sub-assembly with a new or a known good one. Refer to REMOVAL [08/2015 - ] .

   OK

   The operation of the hybrid system indicator returns to normal.

NG → Refer to   9 

OK → END