LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Prius Two >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior Panels / Trim - Service Information (2 Of 2) >> Front Bumper >> Components [07/2020 - ]

Components [07/2020 - ]

Fig 1: Front Bumper Replacement Components (1 Of 6)
GTY895472Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
*1 FRONT BUMPER ASSEMBLY *2 RADIATOR SUPPORT OPENING COVER
Fig 2: Front Bumper Replacement Components (2 Of 6)
GTY902584Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
*A w/ Intuitive Parking Assist System *B w/o Fog Light
*1 CONNECTOR COVER *2 FRONT CENTER ULTRASONIC SENSOR
*3 FRONT CORNER ULTRASONIC SENSOR *4 FRONT CORNER ULTRASONIC SENSOR RETAINER
*5 FRONT SIDE ULTRASONIC SENSOR *6 FRONT SIDE ULTRASONIC SENSOR RETAINER
*7 NO. 3 ENGINE ROOM WIRE - -
• Non-reusable part - -
Fig 3: Front Bumper Replacement Components (3 Of 6)
GTY908580Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
*A w/ Fog Light *B w/o LED Illumination Light
*C w/ LED Illumination Light - -
*1 FOG LIGHT ASSEMBLY LH *2 FOG LIGHT ASSEMBLY RH
*3 FOG LIGHT CORD *4 LED ILLUMINATION LIGHT LH
*5 LED ILLUMINATION LIGHT RH - -
Fig 4: Front Bumper Reinforcement Components With Torque Specifications (4 Of 6)
GTY1007269Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Callout Description Callout Description
*A w/o LED Illumination Light *B w/ LED Illumination Light
*C w/o Fog Light *D w/ Fog Light
*E w/ Pre-collision System - -
*1 FRONT BUMPER SIDE MOULDING LH *2 FRONT BUMPER SIDE MOULDING RH
*3 FRONT FENDER LINER RETAINER *4 HOOD TO FRONT END PANEL SEAL
*5 LOWER NO. 1 RADIATOR GRILLE *6 MILLIMETER WAVE RADAR SENSOR ASSEMBLY
*7 NO. 3 AIR CLEANER INLET *8 RADIATOR GRILLE
*9 RADIATOR GRILLE BRACKET *10 RADIATOR GRILLE SUB-ASSEMBLY
• Non-reusable part - -
Fig 5: Front Bumper Replacement Components (5 Of 6)
GTY904265Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
*1 FRONT BUMPER EXTENSION MOUNTING BRACKET *2 FRONT BUMPER HOLE COVER LH
*3 FRONT BUMPER HOLE COVER RH *4 NO. 1 FRONT BUMPER PAD
*5 NO. 2 FRONT BUMPER PAD *6 RADIATOR GRILLE EMBLEM ASSEMBLY
*7 FRONT BUMPER COVER - -
• Non-reusable part - -
Fig 6: Front Bumper Replacement Components With Torque Specifications (6 Of 6)
GTY920348Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Callout Description Callout Description
*1 FRONT BUMPER ENERGY ABSORBER *2 FRONT BUMPER EXTENSION LH
*3 FRONT BUMPER EXTENSION RH *4 FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
*5 FRONT BUMPER SIDE SUPPORT LH *6 FRONT BUMPER SIDE SUPPORT RH
*7 LOWER FRONT BUMPER ABSORBER *8 NO. 2 FRONT BUMPER REINFORCEMENT
*9 RADIATOR SHUTTER SUB-ASSEMBLY *10 THERMISTOR ASSEMBLY
N*m (kgf*cm, ft.*lbf): Specified torque - -
scientia non olet · About LEMON Manuals