Installation [12/2018 - ]: Procedure

1. Temporarily install the front lower No. 1 suspension arm sub-assembly LH to the front suspension crossmember sub-assembly with the 2 bolts and nut.

1. Connect the front lower No. 1 suspension arm sub-assembly LH to the front lower ball joint assembly LH with the bolt and 2 nuts.

   Torque: 89 N.m (908 kgf.cm, 66 ft./lbf) 

Refer to PROCEDURE - Step 1

See step  22

1. Using SST, fully tighten the bolt (A).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Torque Wrench Fulcrum Length
   	Turn

   • SST: 09961-01270 

   Specified tightening torque 

   Torque: 240 N.m (2447 kgf.cm, 177 ft./lbf) 

   HINT: 

   • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

     Refer to PRECAUTION [12/2018 - 08/2019] , or refer to PRECAUTION [08/2019 - ]

   • When using SST (fulcrum length of 200 mm (7.87 in.)) + torque wrench (fulcrum length of 600 mm (1.97 ft.)):

     180 N.m (1835 kgf.cm, 133 ft./lbf)

2. Fully tighten the bolt (B).

   Torque: 125 N.m (1275 kgf.cm, 92 ft./lbf) 

   NOTE:

   Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

Refer to PROCEDURE - Step 64 [12/2018 - 07/2020] , or refer to PROCEDURE - Step 64 [07/2020 - ]

Refer to PROCEDURE - Step 66 [12/2018 - 07/2020] , or refer to PROCEDURE - Step 66 [07/2020 - ]

Refer to ADJUSTMENT [12/2018 - 07/2020] , or refer to ADJUSTMENT [07/2020 - ]