LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Prius Three >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery / Charging System - Service Information >> Auxiliary Battery >> Installation [11/2015 - 12/2018] >> Procedure

Installation [11/2015 - 12/2018]: Procedure

  1. INSTALL AUXILIARY BATTERY 
    1. w/ Battery Insulator:
      1. Install the battery insulator to the auxiliary battery.
    2. Install the auxiliary battery.
    3. Set the battery clamp sub-assembly as shown in the illustration.
      GTY898093Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Install in this Direction
    4. Install the bolt.

      Torque: 15.4 N.m (157 kgf./cm, 11 ft./bf) 

    5. Connect the cable to the positive (+) auxiliary battery terminal and tighten the nut.

      Torque: 5.6 N.m (57 kgf./cm, 50 in.*lbf) 

    6. Engage the 2 claws to close the battery terminal cap.
  2. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL 
    1. Connect the cable to the negative (-) auxiliary battery terminal and tighten the nut.

      Torque: 5.4 N.m (55 kgf./cm, 48 in.*lbf) 

      NOTE:

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Refer to INITIALIZATION [11/2015 - 11/2017] , or refer to INITIALIZATION [11/2017 - 12/2018]

scientia non olet · About LEMON Manuals