Removal [11/2015 - 11/2017]: Procedure
- PRECAUTION NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Refer to PRECAUTION [11/2015 - 11/2017]
Refer to PRECAUTION [11/2015 - 12/2018]
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 2
- REMOVE INSTRUMENT PANEL FINISH PANEL END RH
Refer to PROCEDURE - Step 14
- REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 15
- REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET
- DISCONNECT STEREO COMPONENT TUNER ASSEMBLY WITH WIRE (w/ Satellite Radio)
- REMOVE NO. 1 RADIO BRACKET
- REMOVE NO. 2 RADIO BRACKET
- REMOVE NAVIGATION RECEIVER ASSEMBLY
- REMOVE STEREO COMPONENT TUNER ASSEMBLY WITH WIRE (w/ Satellite Radio)