Turn Signal Switch Circuit [12/2018 -]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Data List.
5. Read the Data List according to the display on the Techstream.

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Turn Signal Switch (Right)	Turn signal switch (right) signal	OFF or ON	OFF: Turn signal switch (right) off ON: Turn signal switch (right) on	-
   Turn Signal Switch (Left)	Turn signal switch (left) signal	OFF or ON	OFF: Turn signal switch (left) off ON: Turn signal switch (left) on	-
   Turn Switch Signal (Full Turn)	Turn signal switch (full turn) signal	OFF or ON	OFF: Turn signal switch (left and right) off ON: Turn signal switch (left or right) on	-

   Body Electrical > Combination Meter > Data List 

   Tester Display
   Turn Signal Switch (Right)
   Turn Signal Switch (Left)
   Turn Switch Signal (Full Turn)

   OK

   Normal conditions listed above are displayed.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [12/2018 -] 

Result: 

NG 

See step  2

1. Remove the headlight dimmer switch assembly.

   Refer to REMOVAL [12/2018 - 07/2020] , or refer to REMOVAL [07/2020 -]

2. Inspect the headlight dimmer switch assembly.

   Refer to INSPECTION [11/2015 -]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE HEADLIGHT DIMMER SWITCH ASSEMBLY. Refer to  REMOVAL [12/2018 - 07/2020]  , or refer to  REMOVAL [07/2020 -] 

Result: 

OK 

See step  3

1. Disconnect the F7 combination meter assembly (meter circuit plate) connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   & Routing (F64, F7)

   (F64)

   (F7)

   Tester Connection	Condition	Specified Condition
   F64-12 (TR) - F7-5 (ER)	Always	Below 1 Ω
   F64-11 (TL) - F7-11 (EL)	Always	Below 1 Ω
   F64-13 (CR) - F7-9 (SW)	Always	Below 1 Ω
   F64-12 (TR) or F7-5 (ER) - Body ground	Always	10 kΩ or higher
   F64-11 (TL) or F7-11 (EL) - Body ground	Always	10 kΩ or higher
   F64-13 (CR) or F7-9 (SW) - Body ground	Always	10 kΩ or higher
   F64-15 (EL) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [12/2018 -] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR