Freeze Frame Data [09/2016 - 07/2020]
- FREEZE FRAME DATA
- Whenever a meter DTC is detected, the combination meter assembly (meter circuit plate) stores the current vehicle state as freeze frame data.
- CHECK FREEZE FRAME DATA
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Combination Meter / Trouble Codes.
- According to the Techstream display, select a DTC that stored freeze frame data.
- Read the freeze frame data recorded when the DTC was stored.COMBINATION METER
DTC No. Detection Item Displayed Item B1503 Exhaust Heat Management Warning Detected - Trip
- Elapsed time after turning the power switch on (IG)
B1507 Open in Turn Signal Circuit B1508 Short in Turn Signal / Hazard Flasher Circuit B150A Lost Communication with HMI-LAN U0100 Lost Communication with ECM / PCM "A" U0129 Lost Communication with Brake System Control Module U0131 Lost Communication with Power Steering Control Module U0142 Lost Communication with Body Control Module "B" U0151 Lost Communication with Restraints Control Module U0163 Lost Communication with Navigation Control Module U0182 Lost Communication with Lighting Control Module Front U023A Lost Communication with Front Camera Module U0293 Lost Communication with Hybrid Vehicle Control System U1104 Lost Communication with Driving Support ECU
- CLEAR FREEZE FRAME DATA NOTE:
Clearing the DTCs will also clear the freeze frame data.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Clear the DTCs and freeze frame data.
Refer to DTC CHECK / CLEAR [09/2016 - ]
Body Electrical > Combination Meter > Clear DTCs