Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during combination meter assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative (-) auxiliary battery terminal | Memorize steering angle neutral point | Lane departure alert system (w/ Steering Control) | Refer to INITIALIZATION [09/2016 - 07/2020] |
| Intelligent clearance sonar system*1 | |||
| Simple advanced parking guidance system*1 | |||
| Pre-collision system | |||
| Initialize back door lock | Power door lock control system | Refer to INITIALIZATION [09/2016 - ] |
*1: When performing learning using the Techstream.
Refer to CALIBRATION [09/2016 - ]