Washer Fluid Level Warning Switch Circuit [09/2016 - ]: Procedure

1. Remove the level warning switch assembly.

   Refer to REMOVAL [09/2016 - ]

2. Inspect the level warning switch assembly.

   Refer to INSPECTION [09/2016 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE LEVEL WARNING SWITCH ASSEMBLY. Refer to  REMOVAL [09/2016 - ] 

Result: 

OK 

See step  2

1. Disconnect the I6 combination meter assembly (meter circuit plate) connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A25-1 (S) - I6-16 (WLVL)	Always	Below 1 Ω
   A25-1 (S) or I6-16 (WLVL) - Body ground	Always	10 kΩ or higher
   A25-2 (E) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY (METER CIRCUIT PLATE). Refer to  DISASSEMBLY [09/2016 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR