Steering Pad Switch Circuit [09/2016 - ]: Procedure

1. Remove the steering pad switch assembly.

   Refer to REMOVAL [09/2016 - 07/2020] , or refer to REMOVAL [07/2020 - ]

2. Inspect the steering pad switch assembly.

   Refer to INSPECTION [09/2016 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE STEERING PAD SWITCH ASSEMBLY. Refer to  REMOVAL [09/2016 - 07/2020]  , or refer to  REMOVAL [07/2020 - ] 

Result: 

OK 

See step  2

1. Remove the spiral cable sub-assembly.

   Refer to REMOVAL [09/2016 - 07/2020] , or refer to REMOVAL [07/2020 - ]

2. Inspect the spiral cable sub-assembly.

   Refer to INSPECTION [09/2016 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE SPIRAL CABLE SUB-ASSEMBLY. Refer to  REMOVAL [09/2016 - 07/2020]  , or refer to  REMOVAL [07/2020 - ] 

Result: 

OK 

See step  3

1. Disconnect the I6 combination meter assembly (meter circuit plate) connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I23-10 (+DP) - I6-1 (MSM+)	Always	Below 1 Ω
   I23-11 (+DP2) - I6-2 (MSTI)	Always	Below 1 Ω
   I23-10 (+DP) or I6-1 (MSM+) - Body ground	Always	10 kΩ or higher
   I23-11 (+DP2) or I6-2 (MSTI) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY (METER CIRCUIT PLATE). Refer to  DISASSEMBLY [09/2016 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR