Brake Shoes &/Or Pads: Remove & Replace

Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.

Applies To	Note	Standard Hours	Warranty Hours	Skill Level
All	Includes: Disable Brake Control.	2.0		B
Front or Rear,Both Sides	Includes: Disable Brake Control.	1.2		B
Combination Procedure: BRAKE HOSE: Replace:
Each Additional		0.2		B
One	Includes: Bleed Brakes. Includes: Additional time for use of scan tool to perform this procedure.	0.5		B
Combination Procedure: CALIPER: Overhaul:
One	Includes: Bleed Brakes. Includes: Additional time for use of scan tool to perform this procedure.	0.7		B
Combination Procedure: CALIPER: Replace:
One	Includes: Bleed Brakes. Includes: Additional time for use of scan tool to perform this procedure.	0.5		B
Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle:
		0.5		B
Combination Procedure: DISC ROTOR: Correct:
Lateral Runout,Each	Correct Rotor lateral runout by indexing.	0.2		B
Combination Procedure: HUB & ROTOR DISC: Clean & Inspect:
Corrosion,Each	Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor.	0.2		B
Combination Procedure: WHEEL BEARING: Replace:
Front,Hub Assembly,One Side	DOES NOT include wheel alignment.	1.7		B
Rear,Hub Assembly,One Side		0.9		B