On-Vehicle Inspection [11/2015 - 06/2017]: Procedure

INSPECT COMBINATION METER ASSEMBLY

Check speedometer operation.

NOTE:

The combination meter assembly receives the vehicle speed signal from the skid control ECU via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the skid control ECU because it is the source of the vehicle speed signal.
The Data List values of the skid control ECU are used for this inspection. Therefore, make sure to perform the inspection after confirming that no DTCs are output from the brake control system.
If the tire size or tire inflation pressure is not within the specified range, or the tires are excessively worn, the speedometer indication error will increase. Therefore, make sure to perform the inspection after checking that the tire size, tire inflation pressure and tire wear are in the specified range.

Before starting the following inspection, check if the brake control system outputs the DTCs.

Check the values by referring to the table below.

ABS/VSC/TRAC

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
Vehicle Speed	Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (203 mph)	Vehicle stopped: 0 km/h (0 mph)	-

REFERENCE: MPH (FOR U.S.A.)

Techstream indication (mph)	Acceptable Range (mph) Data in () is for reference
20	18.9 to 21.4
40	38.8 to 41.6
60	58.9. to 61.7
80	78.8 to 82.0
100	98.9 to 102.1
120	119.1 to 122.3
140	139.2 to 142.4
160	159.3 to 162.5
180	179.4 to 182.6

REFERENCE: KM/H (FOR CANADA)

Techstream indication (km/h)	Acceptable Range (km/h) Data in () is for reference
20	18.1 to 22.1
40	38.0 to 42.5
60	58.1 to 62.6
80	77.9 to 82.9
100	98.0 to 103.0
120	118.2 to 123.2
140	138.3 to 143.3
160	158.4 to 163.4
180	178.5 to 183.5

CHECK LED ILLUMINATION (BULB CHECK)

Check the illumination function of the warning or indicator lights listed below when turning the ignition switch to ON (IG).

Warning or Indicator Light	Specified Condition
Tire pressure warning light*1	Warning or indicator light comes on for about 3 seconds after turning the ignition switch to ON (IG).
Master warning light
PCS warning light*2
SRS warning light	Warning light comes on for about 6 seconds after turning the ignition switch to ON (IG).
Charge warning light	Warning light comes on when turning the ignition switch to ON (IG).
EPS warning light
MIL (Check engine warning light)
Brake warning light / red (malfunction)	Warning or indicator light comes on for about 3 seconds after turning the ignition switch to ON (IG). Warning or indicator light comes on for about 3 seconds when turning the ignition switch from off to ON (READY).
Slip indicator light
ABS warning light
Brake warning light / yellow (minor malfunction)
VSC OFF indicator light