DTC C1311-11: Open in Main Relay 1 Circuit; DTC C1312-12: Short in Main Relay 1 Circuit [06-2015 - ]: Description

The ABS main relay supplies power to the changeover solenoid and the linear solenoid.

The ABS main relay remains on for approximately 2 minutes after the power switch is turned off and the input of brake pedal operation signals stops, and supplies power to the system to keep it ready to operate.

DTC No.	Detection Item	INF Code	DTC Detection Condition	Trouble Area	Note
C1311/11	Open in Main Relay 1 Circuit	1	Either of the following is detected: When the power switch is on (READY): The ABS main relay contact is not turned ON (BS terminal voltage 3.5 V or more) for 0.2 seconds or more when the ABS main relay ON is requested while IG1 terminal voltage is 9.5 V or more. When the power switch is off: The ABS main relay contact is not turned ON (BS terminal voltage 3.5 V or more) for 0.2 seconds or more when the ABS main relay ON is requested.	Open or short in ABS main relay circuit Skid control ECU (Brake booster with master cylinder assembly)	Electronically controlled brake system DTC
C1312/12	Short in Main Relay 1 Circuit	2	The ABS main relay contact is turned ON (BS terminal voltage 3.5 V or more) for 4.5 seconds or more when the ABS main relay OFF is requested from the ECU.	Short in ABS main relay circuit ABS main relay internal stuck Skid control ECU (Brake booster with master cylinder assembly)	Electronically controlled brake system DTC