DTC C1300: Skid Control ECU Malfunction [06/2015 - ]: Procedure

1. Replace the skid control ECU (brake booster with master cylinder assembly).

   Refer to REMOVAL [06/2015 - 11/2018] , or refer to REMOVAL [11/2018 - ]

2. Perform initialization and calibration of the linear solenoid valve.

   Refer to INITIALIZATION [06/2015 - ]

   Chassis > ABS/VSC/TRAC > Utility 

   Tester Display
   ECB Utility

3. Perform zero point calibration of the yaw rate and acceleration sensor.

   Refer to CALIBRATION [06/2015 - ]

   Chassis > ABS/VSC/TRAC > Utility 

   Tester Display
   Test Mode

4. Perform the sensor check in Test Mode Procedure.

   Refer to TEST MODE PROCEDURE [06/2015 - ]

   Chassis > ABS/VSC/TRAC > Utility 

   Tester Display
   Signal Check

   Result

   Proceed to
   NEXT

Result: 

NEXT 

END