LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Mirai >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display - Service Information >> Light Control Rheostat >> Inspection [06/2015 - ] >> Procedure

Inspection [06/2015 - ]: Procedure

  1. INSPECT LIGHT CONTROL RHEOSTAT 
    1. Inspect light control rheostat switch
      GTY562462Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Light Control Rheostat)
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        2 (DOWN) - 4 (E) Light control rheostat (DOWN) OFF → ON 10 kΩ or higher → Below 1 Ω
        3 (UP) - 4 (E) Light control rheostat (UP) OFF → ON 10 kΩ or higher → Below 1 Ω

        If the result is not as specified, replace the light control rheostat.

    2. Check the illumination operation
      1. Apply auxiliary battery voltage to the trip switch and check that it illuminates.

        OK

        Condition Specified Condition
        Auxiliary battery positive (+) → 5 (ILL+)
        Auxiliary battery positive (-) → 1 (ILL-)        		 The illumination comes on

        If the result is not as specified, replace the light control rheostat.

scientia non olet · About LEMON Manuals