Installation [11/2018 - ]: Procedure

INSTALL COMBINATION METER ASSEMBLY

Engage the clamp.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Engage the clips to install the combination meter assembly as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Install in this Direction

INSTALL LOWER INSTRUMENT PANEL ASSEMBLY
Refer to PROCEDURE - Step 3
INSTALL FRONT PILLAR GARNISH LH
Refer to PROCEDURE - Step 29
INSTALL FRONT PILLAR GARNISH RH
HINT:

Use the same procedure as for the LH side.
CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Refer to PROCEDURE - Step 31
CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
HINT:

Use the same procedure as for the LH side.
INSTALL NO. 1 INSTRUMENT PANEL CUSHION
Refer to PROCEDURE - Step 33
INSTALL FRONT NO. 2 SPEAKER ASSEMBLY
Refer to PROCEDURE - Step 1
INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 35
INSTALL NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
HINT:

Use the same procedure as for the No. 1 instrument panel speaker panel sub-assembly side.
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 2

NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [11/2018 - ]
INSTALL LUGGAGE TRIM SERVICE HOLE COVER
Refer to PROCEDURE - Step 3