Meter Illumination does not Dim at Night [08/2015 - ]: Procedure

1. Check for DTCs (Refer to DTC CHECK / CLEAR [08/2015 - ] ).
   RESULT
   
   

   Result	Proceed to
   CAN communication system DTC is not output	A
   CAN communication system DTC is output	B

Result: 

NG 

GO TO DTC B1244 

Result: 

OK 

See step  2

1. Operate the Techstream according to the display and select Data List (Refer to DATA LIST / ACTIVE TEST [08/2015 - ] ).
   COMBINATION METER
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Tail Cancel SW*	TAIL cancel switch condition/ON or OFF	ON: TAIL cancel switch ON OFF: TAIL cancel switch OFF	-
   Rheostat value	Light control rheostat switch input/Min.: 0, Max.: 100	Light control rheostat switch is fully turned right (0) → fully turned left (100)	Unit: %

   HINT: 

   *: w/ TAIL Cancel Switch

   OK

   Light brightness can be changed within specified range by manual operation.

Result: 

OK 

CHECK CUSTOMIZE SETTING 

(Refer to CUSTOMIZE PARAMETERS [08/2015 - ] )

Result: 

NG 

See step  3

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY 

(Refer to REMOVAL [08/2015 - ] )

Result: 

NG 

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) 

(Refer to REMOVAL [08/2015 - ] )