LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Highlander XLE, FWD >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belts (Service Information) (Except Hybrid) >> Rear No. 2 Seat Inner Belt Assembly >> Inspection [11/2016 - ] >> Procedure

Inspection [11/2016 - ]: Procedure

  1. INSPECT REAR NO. 2 SEAT INNER BELT ASSEMBLY RH 
    1. Measure the resistance according to the value(s) in the table below.
      GTY726025Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Rear No. 2 Seat Inner Belt Assembly RH)

      Standard Resistance

      Tester Connection Condition Specified Condition
      L30-1 - L30-2 Rear No. 2 RH seat belt unfastened Below 1 Ω
      Rear No. 2 RH seat belt fastened 10 kΩ or higher
      L30-4 - E-2 Always Below 1 Ω
      L30-3 - E-1 Always Below 1 Ω

      If the result is not as specified, replace the rear No. 2 seat inner belt assembly RH.

  2. INSPECT REAR NO. 2 SEAT INNER BELT SUB-ASSEMBLY 
    1. Measure the resistance according to the value(s) in the table below.
      GTY726360Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Rear No. 2 Seat Inner Belt Sub-assembly)

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 - 2 Rear No. 2 LH seat belt unfastened Below 1 Ω
      Rear No. 2 LH seat belt fastened 10 kΩ or higher

      If the result is not as specified, replace the rear No. 2 seat inner belt sub-assembly.

scientia non olet · About LEMON Manuals