Removal [02/2014 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- DISCONNECT BRAKE BOOSTER PUMP CONNECTOR
Refer to PROCEDURE - Step 2
- REMOVE FRONT WHEEL
- DRAIN BRAKE FLUID
NOTE:
If brake fluid leaks onto any painted surface, immediately wash it off.
- DISCONNECT FRONT FLEXIBLE HOSE
- Remove the union bolt and gasket, and disconnect the front flexible hose from the front disc brake cylinder assembly.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY
- Hold the 2 front disc brake cylinder slide pins and remove the 2 bolts and front disc brake cylinder assembly.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE FRONT DISC BRAKE PAD
- Remove the 2 anti-squeal springs.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the 2 front disc brake pads from the front disc brake cylinder mounting.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE FRONT DISC BRAKE ANTI-SQUEAL SHIM KIT
- Remove the front disc brake anti-squeal shim from each front disc brake pad.
- Using a screwdriver, remove the front disc brake pad wear indicator plate from each front disc brake pad.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE
- Remove the 4 front disc brake pad support plates from the front disc brake cylinder mounting.
NOTE:
Each front disc brake pad support plate has a different shape. Be sure to put an identification mark on each front disc brake pad support plate so that it can be reinstalled to its original position.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE FRONT NO. 1 DISC BRAKE CYLINDER SLIDE PIN
- Remove the front No. 1 disc brake cylinder slide pin from the front disc brake cylinder mounting.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE FRONT NO. 2 DISC BRAKE CYLINDER SLIDE PIN
- Remove the front No. 2 disc brake cylinder slide pin from the front disc brake cylinder mounting.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Using a screwdriver with its tip wrapped with protective tape, remove the front disc brake cylinder slide bushing from the front No. 2 disc brake cylinder slide pin.
NOTE:
Do not damage the front No. 2 disc brake cylinder slide pin.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE FRONT DISC BRAKE BUSHING DUST BOOT
- Remove the 2 front disc brake bushing dust boots from the front disc brake cylinder mounting.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE FRONT DISC BRAKE CYLINDER MOUNTING
- Remove the 2 bolts and front disc brake cylinder mounting from the steering knuckle.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE FRONT DISC
- Put matchmarks on the front disc and the front axle hub sub-assembly.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the front disc.