LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Highlander XLE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 130 (Air Conditioning System (Service Information) (Hybrid)) >> COMPRESSOR (for 2GR-FXS) >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM 

    See step  1

  2. REMOVE SERVICE PLUG GRIP 

    Refer to REMOVAL [02/2014 - ]

  3. REMOVE RADIATOR ASSEMBLY 

    Refer to REMOVAL [11/2016 - ]

  4. CHECK TERMINAL VOLTAGE 
    1. Remove the inverter terminal cover.

      Refer to PROCEDURE - Step 9

    2. Check the terminal voltage.

      Refer to PROCEDURE - Step 10

    3. Install the inverter terminal cover.

      Refer to PROCEDURE - Step 18

  5. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY 
    1. Remove the bolt and disconnect the discharge hose sub-assembly from the compressor with motor assembly.
      GTY711098Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the O-ring from the discharge hose sub-assembly.
      NOTE:

      Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

  6. DISCONNECT SUCTION HOSE SUB-ASSEMBLY 
    1. Remove the bolt and disconnect the suction hose sub-assembly from the compressor with motor assembly.
      GTY711099Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the O-ring from the suction hose sub-assembly.
      NOTE:

      Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

  7. REMOVE COMPRESSOR WITH MOTOR ASSEMBLY 
    1. Using a screwdriver, slide the green-colored lock of the connector as shown in the illustration to release it and disconnect the connector.
      GTY717734Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Green-colored Lock
      WARNING:

      Make sure to wear insulating gloves.

      NOTE:

      Insulate the disconnected terminals and connector with insulating tape.

    2. Disconnect the connector.
      GTY736311Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the bolt.
    4. Disengage each clamp.
    5. for Type A:
      1. Remove the 2 bolts and bracket.
        GTY687023Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        Bolt
        Nut
      2. Remove the nut.
      3. Using an E8 "TORX" socket wrench, remove the stud bolt and compressor with motor assembly.
        GTY711118Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. for Type B:
      1. Remove the 3 bolts and compressor with motor assembly with bracket.
        GTY688343Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals