Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
| Monitor runs whenever the following DTCs are not stored | None |
| Key-off monitor runs when all of the following conditions are met: | - |
| Atmospheric pressure | 70 kPa (abs) [10.15 psi (abs)] or higher, and less than 111 kPa (abs) [16.1 psi (abs)] |
| Auxiliary battery voltage | 10.5 V or higher |
| Vehicle speed | Less than 4 km/h (2.5 mph) |
| Power switch | Off |
| Engine condition | Not running |
| Key-OFF duration | 5, 7 or 9.5 hours |
| Pressure sensor of canister pump module malfunction (P0452 and P0453) | Not detected |
| Fuel tank pressure sensor malfunction (P1452 and P1453) | Not detected |
| Purge VSV | Not operated by scan tool |
| Vent valve | Not operated by scan tool |
| Fuel vapor-containment valve | Not operated by scan tool |
| Leak detection pump | Not operated by scan tool |
| Both of the following conditions (a) and (b) are met before Key-OFF | - |
| (a) Duration that vehicle is being driven | 5 minutes or more |
| (b) Purge flow | Performed |
| Engine coolant temperature | 4.4°C (40°F) or higher, and less than 35°C (95°F) |
| Intake air temperature | 4.4°C (40°F) or higher, and less than 35°C (95°F) |