DTC P122E: High Pressure Fuel Pump Leak Malfunction [11/2016 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
5. Read the DTCs.

   Powertrain > Engine and ECT > Trouble Codes 

   Result

   Result	Proceed to
   DTC P122E is output	A
   DTC P122E and other DTCs are output	B

   HINT: 

   If any DTCs other than P122E are output, troubleshoot those DTCs first.

Result: 

B 

GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [11/2016 - 10/2017]  or  DIAGNOSTIC TROUBLE CODE CHART [10/2017 - ] 

Result: 

A 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

   Powertrain > Engine and ECT > Trouble Codes 

5. Confirm the freeze frame data and check the vehicle conditions at the time the DTC was stored.
   CONFIRMATION ITEM
   
   

   Engine Speed

   MAF

   MAP

   Coolant Temp

   Intake Air

   Battery Voltage

   Throttle Position

   ISC Flow

   ISC Position

   Fuel Press

   Fuel Pressure Target Value

   Fuel Pump Duty (D4)

   HP FP Discharge Rate

   Injection Way

   IG OFF Elapsed Time

6. Use this information to perform a simulation test.
7. Compare the "Normal Condition" information in the Data List table (reference values) with the freeze frame data listed above and with the simulation test results to determine the problem cause.

   Result

   Result	Proceed to
   The problem cause can be determined	A
   The problem cause cannot be determined	B

Result: 

A 

REPAIR OR REPLACE MALFUNCTIONING PARTS 

Result: 

B 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [11/2016 - ]