LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Highlander XLE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 113 (Engine Cooling System (2GR-FXS) - Service Information - (Hybrid)) >> Water Pump >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY 

    Refer to REMOVAL [11/2016 - ] 

  2. REMOVE V-RIBBED BELT 

    Refer to REMOVAL [11/2016 - ]

  3. REMOVE WATER PUMP PULLEY 
    1. Using SST, hold the water pump pulley.
      GTY624241Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09960-10010 
        1. 09962-01000
        2. 09963-00700
    2. Remove the 4 bolts and water pump pulley.

      HINT: 

      There is not enough clearance to completely remove the water pump pulley from the water pump shaft. Remove the water pump pulley together with the engine water pump assembly.

  4. REMOVE ENGINE WATER PUMP ASSEMBLY 
    1. Remove the 15 bolts, engine water pump assembly, water pump pulley and water pump gasket.
      GTY693329Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals