LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Highlander XLE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 109 (Engine Control System (2GR-FXS) - Service Information - (Hybrid)) >> Engine Coolant Temperature Sensor >> Installation [11/2016 - ] >> Procedure

Installation [11/2016 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR 

    HINT: 

    Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

    Refer to INITIALIZATION [11/2016 - ]

    1. Apply a light coat of engine coolant to the O-ring of the engine coolant temperature sensor.
      NOTE:

      If reusing the engine coolant temperature sensor, be sure to inspect the O-ring.

    2. Install the engine coolant temperature sensor to the water outlet with the clip.
      NOTE:
      • If the engine coolant temperature sensor has been struck or dropped, replace it.
      • Make sure that the O-ring is not cracked or moved out of place when installing the engine coolant temperature sensor.
    3. Connect the engine coolant temperature sensor connector.
  2. INSTALL INLET AIR CLEANER ASSEMBLY 

    See step  6

  3. INSTALL COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 4

  4. INSTALL RADIATOR SIDE SEAL RH 

    Refer to PROCEDURE - Step 5

  5. INSTALL RADIATOR SIDE DEFLECTOR SEAL LH 

    Refer to PROCEDURE - Step 6

  6. ADD ENGINE COOLANT (for Engine) 

    Refer to PROCEDURE - Step 2

  7. INSPECT FOR COOLANT LEAK (for Engine) 

    Refer to PROCEDURE - Step 1

  8. INSTALL V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 74

  9. PERFORM INITIALIZATION 
    1. Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

      Refer to INITIALIZATION [11/2016 - ]

scientia non olet · About LEMON Manuals