Installation [11/2016 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL FRONT NO. 1 STABILIZER BAR BUSHING

Install the 2 front No. 1 stabilizer bar bushings to the front stabilizer bar as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

When installing the front No. 1 stabilizer bar bushings, make sure that the cutout is facing the rear of the vehicle.

INSTALL FRONT NO. 2 STABILIZER BRACKET LH
1. Install the front No. 2 stabilizer bracket LH to the front No. 1 stabilizer bar bushing.
INSTALL FRONT NO. 2 STABILIZER BRACKET RH
HINT:

Perform the same procedure as for the LH side.
INSTALL FRONT STABILIZER BAR
1. Install the front stabilizer bar with 2 front No. 2 stabilizer brackets and 2 front No. 1 stabilizer bar bushings to the front frame assembly.
INSTALL FRONT NO. 1 STABILIZER BRACKET LH
1. Install the front No. 1 stabilizer bracket LH to the front frame assembly with the 2 bolts.
  Torque: 29 N*m (296 kgf*cm, 21 ft.*lbf)
INSTALL FRONT NO. 1 STABILIZER BRACKET RH
HINT:

Perform the same procedure as for the LH side.
INSTALL FRONT FRAME ASSEMBLY
See step 15
INSTALL FRONT STABILIZER LINK ASSEMBLY LH
1. Install the front stabilizer link assembly LH to the front shock absorber assembly and front stabilizer bar with the 2 nuts.
  Torque: 74 N*m (755 kgf*cm, 55 ft.*lbf)
  
  HINT:
  
  If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud bolt.
INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT:

Perform the same procedure as for the LH side.
INSTALL FRONT WHEELS
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
Refer to ADJUSTMENT [11/2016 - ]