LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Highlander XLE, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Engine Lubrication System (2GR-FXE) (Service Information) (Hybrid)) >> Oil Pressure Switch >> Removal [02/2014 - 11/2016] >> Procedure

Removal [02/2014 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT WHEEL RH 
  2. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 11 , or refer to PROCEDURE - Step 11

  3. SEPARATE FRONT FENDER LINER RH 

    Refer to PROCEDURE - Step 15 , or refer to PROCEDURE - Step 15

  4. REMOVE FRONT FENDER APRON SEAL RH 

    Refer to PROCEDURE - Step 17 , or refer to PROCEDURE - Step 17

  5. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Disconnect the wire harness protector.
      GTY429071Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Wire Harness Protector
    2. Disconnect the engine oil pressure switch assembly connector.
    3. Using a 24 mm deep socket wrench, remove the engine oil pressure switch assembly.
      GTY308242Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals