Installation [02/2014 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL PURGE VALVE (PURGE VSV)

Install the purge valve (purge VSV) to the cylinder head sub-assembly with the bolt.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)

Connect the fuel vapor feed hose assembly to the purge valve (purge VSV) and slide the clip to secure it.

HINT:

Engage the clip within the area shown in the illustration.

*1	Fuel Vapor Feed Hose Assembly
*2	No. 1 Fuel Vapor Feed Hose
*a	2 to 7 mm (0.0787 to 0.276 in.)
*b	120°
*c	RH
*d	Paint Mark

Connect the No. 1 fuel vapor feed hose to the purge valve (purge VSV).
Engage the wire harness clamp.
Connect the purge valve (purge VSV) connector.

INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 68 , or refer to PROCEDURE - Step 67
INSTALL INLET NO. 2 AIR CLEANER
Refer to PROCEDURE - Step 5
INSTALL COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 4
INSTALL RADIATOR SIDE SEAL RH
Refer to PROCEDURE - Step 5
INSTALL RADIATOR SIDE DEFLECTOR SEAL LH
Refer to PROCEDURE - Step 6