Installation [02/2014 - 11/2016]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL ENGINE COOLANT TEMPERATURE SENSOR
HINT:
Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Refer to INITIALIZATION [02/2014 - 11/2016]
- Install a new gasket to the engine coolant temperature sensor.
- Using a 19 mm union nut wrench, install the engine coolant temperature sensor to the water outlet.
Torque: 19.6 N*m (200 kgf*cm, 14 ft.*lbf)
NOTE:- If the engine coolant temperature sensor has been struck or dropped, replace it.
- Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a union nut wrench.
Refer to PRECAUTION [02/2014 - 11/2016]
- Connect the engine coolant temperature sensor connector.
- INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
See step 3
- INSTALL INLET NO. 1 AIR CLEANER
See step 4
- INSTALL INLET NO. 2 AIR CLEANER
See step 5
- INSTALL COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 4
- INSTALL RADIATOR SIDE SEAL RH
Refer to PROCEDURE - Step 5
- INSTALL RADIATOR SIDE DEFLECTOR SEAL LH
Refer to PROCEDURE - Step 6
- INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 68 , or refer to PROCEDURE - Step 67
- INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 10 , or refer to PROCEDURE - Step 10
- INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
Refer to INSTALLATION [02/2014 - ]
- ADD ENGINE COOLANT
Refer to PROCEDURE - Step 3
- INSPECT FOR COOLANT LEAK (for Engine)
Refer to PROCEDURE - Step 1
- PERFORM INITIALIZATION
- Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Refer to INITIALIZATION [02/2014 - 11/2016]
- Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.