DTC P0705: Transmission Range Sensor Circuit (PRNDL Input) [12/2013 - 11/2016]: Description

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

The park/neutral position switch assembly detects the shift lever position and sends a signal to the ECM.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area	MIL	Memory	Note
P0705	Transmission Range Sensor Circuit (PRNDL Input)	One of the following conditions A, B or C is met (2 trip detection logic): A. One of the following conditions (a), (b) or (c) is met for 2 seconds or more: (a) Any 2 or more of the following signals are on simultaneously: P input signal R input signal D input signal (b) Any 2 or more of the following signals are on simultaneously: N input signal R input signal D input signal (c) Any 2 or more of the following signals are on simultaneously: NSW input signal R input signal D input signal B. Any of the following conditions is met for 2 seconds or more in the S position: NSW input signal is on P input signal is on N input signal is on R input signal is on C. All switches are off simultaneously for NSW, P, R, N and D for 1 minute or more.	Open or short in park/neutral position switch assembly circuit Park/neutral position switch assembly Open or short in transmission control switch circuit Transmission floor shift assembly ECM	Comes on	DTC stored	DTC for Mexico Models - Applies

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

Memory

Note

P0705

Transmission Range Sensor Circuit (PRNDL Input)

One of the following conditions A, B or C is met (2 trip detection logic):
A. One of the following conditions (a), (b) or (c) is met for 2 seconds or more:
(a) Any 2 or more of the following signals are on simultaneously:

P input signal
R input signal
D input signal

(b) Any 2 or more of the following signals are on simultaneously:

N input signal
R input signal
D input signal

NSW input signal
R input signal
D input signal

B. Any of the following conditions is met for 2 seconds or more in the S position:

NSW input signal is on
P input signal is on
N input signal is on
R input signal is on

C. All switches are off simultaneously for NSW, P, R, N and D for 1 minute or more.

Open or short in park/neutral position switch assembly circuit
Park/neutral position switch assembly
Open or short in transmission control switch circuit
Transmission floor shift assembly
ECM

Comes on

DTC stored

DTC for Mexico Models
- Applies