DTC P0630: VIN not Programmed or Mismatch - ECM / PCM [12/2013 - 11/2015]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- READ OUTPUT DTC (DTC P0630)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
NOTE:If P0630 is output, the VIN must be input to the ECM using the Techstream. However, all DTCs are cleared automatically by the Techstream when the VIN is input. If DTCs other than P0630 are output, troubleshoot them first.
Result Proceed to DTC P0630 is output A DTC P0630 and other DTCs are output B
Result:
B
GO TO DTC CHART.
Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2013 - 08/2014]
Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2014 - 11/2015]
Result:
A
See step 2
- INPUT VIN
- Input the VIN.
Refer to REGISTRATION [12/2013 - 11/2016]
Result:
NEXT
END
- Input the VIN.