LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Highlander XLE, AWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System (2GR-FKS) (Service Information) (Except Hybrid) >> HEATED OXYGEN SENSOR (for Bank 2) >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

  1. REMOVE FRONT FLOOR COVER LH 

    Refer to PROCEDURE - Step 3

  2. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 8

  3. REMOVE NO. 2 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 9

  4. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 4

  5. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Lower Side) 

    Refer to PROCEDURE - Step 9

  6. REMOVE FRONT EXHAUST PIPE ASSEMBLY 

    Refer to PROCEDURE - Step 10

  7. REMOVE HEATED OXYGEN SENSOR 
    1. Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.
      GTY613516Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09224-00012 
      NOTE:

      If the heated oxygen sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals