LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Highlander SE, FWD >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belts (Service Information) (Except Hybrid) >> REAR CENTER SEAT INNER BELT ASSEMBLY (for Rear No. 1 Seat) >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

  1. REMOVE REAR NO. 1 SEAT ASSEMBLY 

    Refer to REMOVAL [12/2013 - ]

  2. REMOVE REAR SEAT REAR CUSHION MOULDING RH 

    Refer to PROCEDURE - Step 6

  3. REMOVE REAR SEAT INNER BELT ASSEMBLY 
    1. Remove the 2 hog rings.
      GTY712671Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Hook
      *b Hog Ring
    2. Disengage the hook.
    3. Remove the wire harness clamp.
      GTY731789Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disengage the 2 clamps.
    5. Disconnect the 2 connectors.
    6. Pass the rear seat inner belt assembly through the rubber band of the rear seat cushion assembly as shown in the illustration.
      GTY708222Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Rubber Band
    7. Remove the bolt and rear seat inner belt assembly.
      GTY726785Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals