Installation [11/2016 - ]: Procedure

1. Install the rear seat inner belt assembly with the bolt.

   Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf) 

   NOTE:

   Do not allow the anchor part of the rear seat inner belt assembly to overlap the protruding parts of the seatback frame.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Protruding Part

2. Pass the rear seat inner belt assembly through the rubber band of the rear seat cushion assembly as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Rubber Band

3. Connect the 2 connectors.
4. Engage the 2 clamps.
5. Install a new wire harness clamp.
6. Engage the hook.
7. Using hog ring pliers, install 2 new hog rings.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Hook
   *b	Hog Ring

   NOTE:

   • Be careful not to damage the separate type rear seat cushion cover.
   • Be sure to securely install the hog rings as shown in the illustration.

Refer to PROCEDURE - Step 46

Refer to INSTALLATION [12/2013 - ]