LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Highlander SE, FWD >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belts (Service Information) (Except Hybrid) >> REAR CENTER SEAT INNER BELT ASSEMBLY (for Rear No. 1 Seat) >> Inspection [11/2016 - ] >> Procedure

Inspection [11/2016 - ]: Procedure

  1. INSPECT REAR SEAT INNER BELT ASSEMBLY 
    1. Measure the resistance according to the value(s) in the table below.
      GTY727831Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Rear Seat Inner Belt Assembly)

      Standard Resistance

      Tester Connection Condition Specified Condition
      i2-2 - i2-5 Rear No. 1 center seat belt unfastened Below 1 Ω
      Rear No. 1 center seat belt fastened 10 kΩ or higher
      i2-1 - C-3 Always Below 1 Ω
      i2-4 - C-2 Always Below 1 Ω

      If the result is not as specified, replace the rear seat inner belt assembly.

scientia non olet · About LEMON Manuals