LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Highlander SE, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Lubrication System (2GR-FE) (Service Information) (Except Hybrid)) >> Oil Pressure Switch >> Removal [12/2013 - 11/2016] >> Procedure

Removal [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT WHEEL RH (w/ Oil Cooler) 
  2. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 8

  3. SEPARATE FRONT FENDER LINER RH (w/ Oil Cooler) 

    Refer to PROCEDURE - Step 12

  4. REMOVE FRONT FENDER APRON SEAL RH (w/ Oil Cooler) 

    Refer to PROCEDURE - Step 14

  5. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Disconnect the wire harness protector. (w/ Oil Cooler)
      GTY429071Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Wire Harness Protector
    2. Disconnect the oil pressure switch assembly connector.
    3. Using a 24 mm deep socket wrench, remove the engine oil pressure switch assembly.
      GTY438268Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A w/ oil cooler
      *B w/o oil cooler
scientia non olet · About LEMON Manuals