LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Highlander LE Plus, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 36 (Transfer Case (Service Information) (Except Hybrid)) >> Transfer Assembly >> Removal [12/2013 - 11/2016] >> Procedure

Removal [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY 

    Refer to REMOVAL [12/2013 - 11/2016]

  2. REMOVE TRANSFER ASSEMBLY 
    1. Remove the 8 nuts.
      GTY439006Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a plastic hammer, remove the transfer assembly from the automatic transaxle assembly.
      NOTE:
      • Remove the transfer assembly from the automatic transaxle assembly without tilting it.
      • During removal, do not hold the transfer assembly by the oil seals on either side of the transfer assembly.
    3. Remove the 4 transfer and transaxle setting stud bolts from the automatic transaxle assembly.
      GTY302974Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals