Typical Enabling Conditions
WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
| Monitor runs whenever the following DTCs are not present | None |
| All of the following conditions are met | - |
| Battery voltage | 8 V or higher |
| Ignition switch | ON |
| Starter | Off |
| Time after ignition switch off to ON | 3 seconds or more |
| Engine | Running |
| Transaxle counter gear revolution | 300 rpm or higher |
| Lost communication with TCM (U0101) | Not detected |
| Either of the following conditions is met | 1 or 2 |
| 1. All of the following conditions are met | - |
| Engine coolant temperature | 20°C (68°F) or higher |
| Engine coolant temperature sensor circuit fail (P0115, P0117, P0118, P0125) | Not detected |
| Time after park/neutral position switch on to off | 2 seconds or more |
| 2. Both of the following conditions are met | - |
| Either of the following conditions is met | A or B |
| A. Engine coolant temperature | Less than 20°C (68°F) |
| B. Engine coolant temperature sensor circuit fail (P0115, P0117, P0118, P0125) | Detected |
| Time after park/neutral position switch on to off | 30 seconds or more |