LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Highlander LE Plus, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Engine Control System (2GR-FE) (Service Information) (Except Hybrid)) >> Engine Coolant Temperature Sensor >> Removal [12/2013 - 11/2016] >> Procedure

Removal [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. DRAIN ENGINE COOLANT 

    Refer to PROCEDURE - Step 2

  2. REMOVE V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25

  3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    1. Disconnect the engine coolant temperature sensor connector.
      GTY444085Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a 19 mm union nut wrench, remove the engine coolant temperature sensor from the cylinder head sub-assembly.
      NOTE:

      If the engine coolant temperature sensor has been struck or dropped, replace it.

    3. Remove the gasket from the engine coolant temperature sensor.
scientia non olet · About LEMON Manuals