LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Highlander LE Plus, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Engine Control System (2GR-FE) (Service Information) (Except Hybrid)) >> Crankshaft Position Sensor >> Removal [12/2013 - 11/2016] >> Procedure

Removal [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE COMPRESSOR ASSEMBLY WITH PULLEY 

    Refer to REMOVAL [12/2013 - 11/2016]

  2. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the crankshaft position sensor connector.
    2. Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.
      GTY144955Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      If the crankshaft position sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals