Installation [12/2013 - 11/2016]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL CRANKSHAFT POSITION SENSOR
- Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
*a O-ring - Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
NOTE:- If the crankshaft position sensor has been struck or dropped, replace it.
- Make sure that the O-ring is not cracked or does not move out of place during installation.
- Connect the crankshaft position sensor connector.
- Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
- INSTALL COMPRESSOR ASSEMBLY WITH PULLEY
Refer to INSTALLATION [12/2013 - 11/2016]
- INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 5