Removal [12/2013 - 11/2016]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE INTAKE AIR SURGE TANK ASSEMBLY
Refer to REMOVAL [12/2013 - 11/2016]
- REMOVE CAMSHAFT POSITION SENSOR (for Intake Side of Bank 1)
- Disconnect the camshaft position sensor connector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.
NOTE:
If the camshaft position sensor has been struck or dropped, replace it.
- REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side of Bank 1)
- Disconnect the camshaft position sensor connector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.
NOTE:
If the camshaft position sensor has been struck or dropped, replace it.
- REMOVE CAMSHAFT POSITION SENSOR (for Intake Side of Bank 2)
- Disconnect the camshaft position sensor connector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly LH.
NOTE:
If the camshaft position sensor has been struck or dropped, replace it.
- REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side of Bank 2)
- Disconnect the camshaft position sensor connector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly LH.
NOTE:
If the camshaft position sensor has been struck or dropped, replace it.