LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Highlander LE Plus, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Lubrication System (2GR-FE) (Service Information) (Except Hybrid)) >> Oil Pressure Switch >> Installation [12/2013 - 11/2016] >> Procedure

Installation [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

      Adhesive

      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      GTY445402Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Adhesive 1344
    2. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

      Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

      NOTE:

      Do not start the engine within 1 hour of installation.

    3. Connect the engine oil pressure switch assembly connector.
    4. Connect the wire harness protector. (w/ Oil Cooler)
  2. ADD ENGINE OIL 

    See step  4

  3. INSPECT FOR OIL LEAK 

    See step  5

  4. INSTALL FRONT FENDER APRON SEAL RH (w/ Oil Cooler) 

    Refer to PROCEDURE - Step 91

  5. INSTALL FRONT FENDER LINER RH (w/ Oil Cooler) 

    Refer to PROCEDURE - Step 93

  6. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 96

  7. INSTALL FRONT WHEEL RH (w/ Oil Cooler) 
scientia non olet · About LEMON Manuals