LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Highlander LE Plus, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Lubrication System (2GR-FE) (Service Information) (Except Hybrid)) >> Engine Oil Cooler >> Installation [12/2013 - 11/2016] >> Procedure

Installation [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL OIL COOLER ASSEMBLY 
    1. Clean the installation surfaces of the oil cooler assembly.
    2. Install a new O-ring to the oil cooler assembly.
    3. Apply a small amount of engine oil to the oil cooler union bolt.
    4. Install the oil cooler assembly with the oil cooler union bolt.

      Torque: 68 N*m (693 kgf*cm, 50 ft.*lbf) 

    5. Install the No. 4 water by-pass hose and No. 5 water by-pass hose and slide the 4 clips to secure them.
    6. Engage the 2 clamps to install the 2 hose clamps.
    7. Install the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

  2. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH 

    Refer to INSTALLATION [12/2013 - 11/2016]

  3. ADD ENGINE COOLANT 

    Refer to PROCEDURE - Step 3

  4. ADD ENGINE OIL 

    See step  4

  5. INSPECT FOR COOLANT LEAK 

    Refer to PROCEDURE - Step 1

  6. INSPECT FOR OIL LEAK 

    See step  5

scientia non olet · About LEMON Manuals