Caution / Notice / Hint

NOTE:

Inspect the fuses for circuits related to this system before performing the following procedure.
If the sliding roof ECU (sliding roof drive gear sub-assembly) is removed and reinstalled or replaced, the sliding roof ECU (sliding roof drive gear sub-assembly) must be initialized.
Refer to INITIALIZATION [12/2013 - ] .
The sliding roof system uses the LIN communication system. First, confirm that there are no malfunctions in the LIN communication system. Refer to How to Proceed with Troubleshooting.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2013 - ] .
If a sliding roof ECU (sliding roof drive gear sub-assembly) DTC is output, first perform troubleshooting for the sliding roof ECU (sliding roof drive gear sub-assembly) DTC.
Refer to DTC CHECK / CLEAR [12/2013 - ] .