DTC C1691: Back Camera Initialization Incomplete [12/2013 - ]: Procedure

1. Perform the following procedure depending on the memory conditions to register the vehicle information into the television camera assembly.
   1. Television camera assembly optical axis adjustment (back camera position setting).

      Refer to CALIBRATION [12/2013 - 11/2016] Refer to CALIBRATION [11/2016 - ]

NEXT 

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [12/2013 - 11/2016] Refer to DTC CHECK / CLEAR [11/2016 - ]

   Chassis > Advanced Parking Guidance/Parking Assist Monitor > Clear DTCs 

2. Recheck for DTCs and check that no DTCs are output.

   Refer to DTC CHECK / CLEAR [12/2013 - 11/2016] Refer to DTC CHECK / CLEAR [11/2016 - ]

   Chassis > Advanced Parking Guidance/Parking Assist Monitor > Trouble Codes 

   HINT: 

   • If DTC C1691 is output, perform the television camera assembly optical axis adjustment (back camera position setting) again.
   • If DTC C1691 is still output after performing the television camera assembly optical axis adjustment 3 times, replace the television camera assembly.

   Result

   Result	Proceed to
   DTC C1691 is output	A
   DTC C1691 is not output	B

Result:  1

A 

REPLACE TELEVISION CAMERA ASSEMBLY. Refer to  REMOVAL [12/2013 - ] 

Result:  2

B 

END