DTC P0775-14: Pressure Control Solenoid "B" Circuit Short to Ground or Open [11/2016 - 10/2017]: Procedure
- CHECK HARNESS AND TRANSMISSION WIRE (TRANSMISSION WIRE (SOLENOID (SL2) VALVE) - ECM)
- Disconnect the C1 ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition C1-31 (SL2+) - C1-1 (SL2-) 20°C (68°F) 5.0 to 5.6 Ω C1-31 (SL2+) or C1-1 (SL2-) - Body ground and other terminals Always 10 kΩ or higher Result
Proceed to OK NG
Result: 2
NG
See step 3
Result: 1
OK
See step 2
- REPLACE ECM
- Replace the ECM.
Refer to COMPONENTS [11/2016 - ]
Result
Proceed to NEXT
Result: 1
NEXT
PERFORM REGISTRATION. Refer to REGISTRATION [11/2016 - ]
- Replace the ECM.
- CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM)
- Disconnect the C62 transmission wire connector.
- Disconnect the C1 ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition C62-19 (SL2+) - C1-31 (SL2+) Always Below 1 Ω C62-18 (SL2-) - C1-1 (SL2-) Always Below 1 Ω C62-19 (SL2+) or C1-31 (SL2+) - Body ground and other terminals Always 10 kΩ or higher C62-18 (SL2-) or C1-1 (SL2-) - Body ground and other terminals Always 10 kΩ or higher Result
Proceed to OK NG
Result: 2
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TRANSMISSION WIRE - ECM)
Result: 1
OK
See step 4
- INSPECT SOLENOID (SL2) VALVE
- Remove the solenoid (SL2) valve.
*a Component without harness connected
(Solenoid (SL2) Valve)Refer to DISASSEMBLY [11/2016 - ]
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition Solenoid (SL2) valve connector terminal 1 - terminal 2 20°C (68°F) 5.0 to 5.6 Ω - Connect a positive (+) lead from the battery with a 21 W bulb to terminal 1 and a negative (-) lead to terminal 2 of the solenoid valve connector. Check that the valve moves and makes an operating sound.
OK
Valve moves and makes an operating sound.
Result
Proceed to OK NG
Result: 1
OK
REPAIR OR REPLACE TRANSMISSION WIRE. Refer to COMPONENTS [11/2016 - ]
Result: 2
NG
REPLACE SOLENOID (SL2) VALVE. Refer to COMPONENTS [11/2016 - ]
- Remove the solenoid (SL2) valve.