Removal [12/2013 - ]: Procedure

REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY
for 2WD: Refer to REMOVAL [12/2013 - 11/2015] , or refer to REMOVAL [11/2015 - 11/2016] , or refer to REMOVAL [11/2016 - ]

for AWD: Refer to REMOVAL [12/2013 - 11/2015] , or refer to REMOVAL [11/2015 - ]
SEPARATE SKID CONTROL SENSOR WIRE LH (for 2WD)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Remove the 2 bolts and separate the skid control sensor wire LH from the rear upper control arm assembly LH.
SEPARATE REAR SPEED SENSOR LH (for AWD)
HINT:

Perform the same procedure as for the skid control sensor wire LH.

SEPARATE SKID CONTROL SENSOR WIRE RH (for 2WD)

Remove the 2 bolts and separate the skid control sensor wire RH from the rear upper control arm assembly RH.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

SEPARATE REAR SPEED SENSOR RH (for AWD)
HINT:

Perform the same procedure as for the skid control sensor wire RH.

REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH

Remove the bolt, nut and rear upper control arm assembly LH from the rear suspension member sub-assembly.

NOTE:

Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.

REMOVE REAR UPPER CONTROL ARM ASSEMBLY RH
HINT:

Perform the same procedure as for the LH side.