Installation [11/2016 - ]: Procedure

1. Install the front stabilizer bar protector to the front stabilizer bar as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Front Stabilizer Bar Protector
   *a	Stopper (RH Side)
   	Inside of the Vehicle

   Dimension (A)

   0 to 5 mm (0 to 0.1969 in.)

2. Install the clip.

1. Install the 2 front No. 1 stabilizer bar bushings to the front stabilizer bar as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Cutout
   	Front of the Vehicle
   	Inside of the Vehicle

   NOTE:

   When installing the front No. 1 stabilizer bar bushings, make sure that the cutout is facing the rear of the vehicle.

1. Install the front No. 2 stabilizer bracket LH to the front No. 1 stabilizer bar bushing.

HINT: 

Perform the same procedure as for the LH side.

1. Install the front No. 1 stabilizer bracket LH to the front No. 1 stabilizer bar bushing.

HINT: 

Perform the same procedure as for the LH side.

1. Temporarily install the front stabilizer bar to the vehicle body.
   NOTE:

   Use wire or an equivalent tool to secure the front stabilizer bar.

See step  14

1. Install the front stabilizer link assembly LH to the front shock absorber assembly and front stabilizer bar with the 2 nuts.

   Torque: 74 N*m (755 kgf*cm, 55 ft.*lbf) 

   HINT: 

   If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud bolt.

HINT: 

Perform the same procedure as for the LH side.

Refer to ADJUSTMENT [11/2016 - ]