Installation [12/2013 - 11/2016]: Procedure

1. Install the 2 front No. 1 stabilizer bar bushings to the front stabilizer bar as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Cutout
   	Front of the Vehicle
   	Inside of the Vehicle

   NOTE:

   When installing the front No. 1 stabilizer bar bushings, make sure that the cutout is facing the rear of the vehicle.

1. Install the front stabilizer bar with 2 front No. 1 stabilizer bar bushings to the vehicle.

Refer to PROCEDURE - Step 3

1. Install the front No. 2 stabilizer bracket LH to the front No. 1 stabilizer bar bushing.

HINT: 

Perform the same procedure as for the LH side.

Refer to PROCEDURE - Step 6

1. Install the front No. 1 stabilizer bracket LH to the front frame assembly with the 2 bolts.

   Torque: 29 N*m (296 kgf*cm, 21 ft.*lbf) 

HINT: 

Perform the same procedure as for the LH side.

1. Install the front stabilizer link assembly LH to the front shock absorber assembly and front stabilizer bar with the 2 nuts.

   Torque: 74 N*m (755 kgf*cm, 55 ft.*lbf) 

   HINT: 

   If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud bolt.

HINT: 

Perform the same procedure as for the LH side.

Refer to PROCEDURE - Step 11