LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Highlander LE Plus, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System (Service Information) (Except Hybrid) >> Navigation Receiver >> Installation [12/2013 - ] >> Procedure

Installation [12/2013 - ]: Procedure

  1. INSTALL NAVIGATION RECEIVER ASSEMBLY 
  2. INSTALL NO. 1 RADIO RECEIVER BRACKET 
    1. Install the No. 1 radio receiver bracket with the 3 screws.
  3. INSTALL NO. 2 RADIO RECEIVER BRACKET 
    1. Install the No. 2 radio receiver bracket with the 3 screws.
  4. INSTALL STEREO COMPONENT TUNER ASSEMBLY WITH WIRE (w/ Satellite Radio) 

    Refer to PROCEDURE - Step 3

  5. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET 
    1. Connect each connector.
    2. Engage the 2 claws and 2 clips to temporarily install the navigation receiver assembly with bracket.
    3. Install the navigation receiver assembly with bracket with the 4 bolts.
  6. INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 25

  7. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 26

  8. INSTALL CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL 

    Refer to PROCEDURE - Step 27

  9. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL WITH AIR CONDITIONING CONTROL ASSEMBLY 

    Refer to PROCEDURE - Step 28

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [12/2013 - 11/2016] Refer to INITIALIZATION [11/2016 - ]

scientia non olet · About LEMON Manuals